SATO 105/106 Labeler Operating Instructions

Step 1	Tear off and discard the 1st ten inches of the SOPB1 labels and liner.
Step 2	Lift the label roll holder open (as indicated on pivoting door with thumb hold).
Step 3	Slide the label roll onto the hub of the label roll holder with the labels feeding in a downward direction from the back of the label roll (toward the rear of the labeler). Close the pivoting door with thumb hold.
Step 4	Turn the labeler upside-down and open the bottom cover, which reads "lift" near the back of the bottom cover.
Step 5	Pull the platen assembly (black plastic piece with steel roller) up and swing back towards the labeler handles.
Step 6	Turn the labeler right side up and feed the label strip down the label path as shown until the label strip protrudes from the bottom. It should come out the bottom in front of the platen.
Step 7	Turn the labeler over (upside down) again. Pull the label strip slightly snug. Continue to hold the label strip while you close or push the platen back into original position.
Step 8	Hold the platen firmly closed and activate the handle 5 to 10 times. The label strip should advance smoothly and the drive wheel inside the labeler should punch out the feed notches. Activate the handle until the holes are punched.
Step 9	Position the label strip end so that the notches will line up with exposed pegs on the drive wheel.
Step 10	Close bottom cover & push firmly on the area that reads "push" until it clicks.
Step 11	The loading process should be complete at this time. Test the label feed by activating the handle a few times until labels are presented correctly just below the rubber roller at the front of the labeler & until the liner protrudes from the back of the labeler without labels attached to it.

Specifications subject to change without notice.

RACO Industries has competitive prices and quality, guaranteed. View our Manufacturers Listing Page to see a listing of manufacturers with their products that we sell or visit our Home Page to learn more about the products that we carry and about RACO Industries. To hear our most recent low prices just call us at 513-984-2101 or 800-446-1991!

RACO Industries also carries a full line of barcoding printers, supplies, software and accessories. Call for more details!

© RACO Industries. Specifications and prices listed are subject to change without notice. All products and brand names are trademarks of their respective companies. All rights reserved.