View larger image

cab A4+M Printer

The center aligned
The center aligned material guidance allows printing on very narrow and thick material, especially flat pressed heat shrink tubes. It is not necessary to re-adjust the print head for different material sizes.

The cab A4+M can handle standard or special materials.

cab A4+M Printer Highlights

• Technical details
  The handling, the electronic, the print heads, the software and the mechanical components are extensively taken from the transfer printer A4+.
• Material guide
  Due to the center alignment of the materials within the machine there is no need to adjust the print heads for different widths any more.
  The guide is placed directly behind the printing line. The adjustment is taken with a spindle.
• Shaft media roll
  Appropriate for cores from 38mm diameter. The material is placed in the roll retainer and automatically adjusted with the margin stop.
• Material sensor
  For identification of punching and reflecting marks as well as label start and end of material.
• Ribbon
  It is placed upon the three part tightening axle and adjusted with the positioning indicator. A spacer can be used alternatively.
• Control
  The print data is automatically printed centric. To reduce the wastage after loading labels or prefabricated heat shrink tubes the materials located between gap sensor and print head can be labeled as well by designating the material gap.
• Stand-alone operation
  The layout of the labels is created either with the label software or directly on the PC. Label formats, fonts and graphic data, serial data and data base contents are saved on the CF memory card or on the internal IFFS printer memory.
  Only the variable data is sent to the printer via keyboard or host computer before being printed out.