cab A+ and A1000 Applicators
Print and Apply in real
time
The applicator A1000 represents in combination with the
thermal printers A2+, A4+ and A6+ the inexpensive solution
both for semi-automatic labeling and for the integration
into automated production lines.
cab A+ and A1000 Applicator Highlights
Long operation lines
The guides have ball bearings which avoid abrasion.
Variable product
heights
With the pneumatic cylinder it is possible to compensate
differences in product heights. It is available in different
heights of stroke.
Simple adjustment
Four screws are needed to adjust the tamp pad to the
dispensing edge. The processing can be optimized at the
operator panel during the testing.
Pre-dispense key
Tests the labeling function. At the first operation the
label is printed and then transferred via the applicator. By
pushing the button again the label is applied.
Air service unit
The mounting takes place directly on the printer. The micro
strainer prevents contamination, the compressed air
regulator guarantees the labeling quality.
High process
reliability
The supporting air jet streaming, the vacuum and the speed
of the cylinder are adjustable. For highly sensitive
products and packaging the pressure to apply labels can be
reduced to less than 1 kg. Consequently there is no risk of
injury. To avoid contamination within the vacuum channels
are cleaned by an air pressure impulse at the end of each
application.
Real-time labeling
Labels with a height of 25 - 200 mm and with a width of 25 -
176 mm can be applied.
Quick assembly
Like any other accessory, the applicator is plugged into the
printer with two stoppers and can be attached with only one
screw.
Digital I/O-Interface
The master (e.g. PLC) starts or stops the labeling process.
The status and error messages are issued at the same time.
The applicator A 1000 represents, in combination with the
thermal printers A2+, A4+ and A6+, the most economic
solution for both semi-automatic labeling and the
integration into automated production lines.
|
